
Configuring Dial Services
A-2 114062 Rev. B
You can use Site Manager to edit all dial service parameters.You can also use the
Technician Interface to modify parameters by issuing
set and commit commands
with the Management Information Base (MIB) object ID. This process is the same
as modifying parameters using Site Manager. For more information about using
the Technician Interface to access the MIB, refer to Using Technician Interface
Software.
Circuit Schedule Parameters (Demand and Dial Backup) page A-45
Demand Circuit Group Parameters page A-49
Demand Circuit Group Protocol Parameters page A-52
Caller Resolution Info Parameters for Demand Circuit Groups page A-50
PPP Circuit Options Parameters (Dial Backup) page A-55
PPP Primary Circuit Definition Parameters (Dial Backup) page A-56
Frame Relay Interface Type Parameter (Dial Backup) page A-57
Frame Relay Primary Interface Definition Parameters (Dial Backup) page A-59
Frame Relay Interface Parameters (Demand and Dial Backup) page A-60
Service List Parameter (Demand and Dial Backup) page A-69
Frame Relay PVC Parameters (Demand and Dial Backup) page A-70
Bandwidth-on-Demand Circuit Options Parameters page A-75
Bandwidth-on-Demand Circuit Definition Parameters page A-77
Bandwidth-on-Demand Congestion Monitor Parameters page A-78
Bandwidth Allocation Protocol (BAP) Parameters page A-84
BRI Configuration Parameters page A-85
Outgoing Phone List Parameters page A-88
Phone Number Parameters (Outgoing) page A-96
Incoming Phone List Parameters page A-101
Phone Number Parameters (Incoming) page A-102
Caller Resolution Table Parameters page A-103
Caution: The Technician Interface does not verify that the value you enter for
a parameter is valid. Entering an invalid value can corrupt your configuration.
Table A-1. Organization of Parameters
(continued)
Parameter Section Location
Comentários a estes Manuais