Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 341)

Using Syslog Messaging to Monitor Router Events

117381-A Rev. A C-19

Task 6: Adding an Entity Filter for a Remote Host

Once you deﬁne a host in the Syslog host table, add (deﬁne) an entity-speciﬁc

message ﬁlter for the host.

If this is not the ﬁrst ﬁlter for a given entity and remote host pair, ﬁrst obtain a list

of ﬁlter instances, as follows:

list -i wfSyslogEntFltrEntry

From the resulting list of instance IDs (of the form

<host_IP_address>.<entity_code>.<ﬁlter_index>), determine the next

<ﬁlter_index> number available to assign to a new ﬁlter, for a given

<host_IP_address>.<entity_code> pair. The number you assign to the new ﬁlter

will have a value of one higher than the highest <ﬁlter_index> in the list.

Now proceed to step 1.

1. Create a new ﬁlter for the desired entity and remote host pair by ﬁrst

creating an entry in the Syslog Entity Filter table, as follows:

$: set WfSyslogEntityFilterTable.WfSyslogEntFltrDelete.

<host_IP_address>.<entity_code>.<ﬁlter_index>

1;commit

<host_IP_address> is the IP address of the desired remote host (a

management workstation).

<entity_code> identiﬁes the software entity for which you want Syslog to

forward event messages to the remote host at the <host_IP_address>.

<ﬁlter_index> is the next available index number you can assign to a ﬁlter for

the desired entity and remote host pair.

2. After you create an entity ﬁlter for a speciﬁc host, deﬁne

• An event number (or range) and a slot number (or range)

• A severity mask and a slot number (or range)

Note: The ﬁlter remains inactive until you deﬁne the event and slot number(s),

or the severity mask and slot number(s).

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 381 382

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 341