Avaya Using Technician Interface Software Manual do Utilizador Página 292

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 382
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 291
Using Technician Interface Software
B-2 117381-A Rev. A
This section describes
The asynchronous terminal program available on UNIX and
386/486 DOS remote workstations
The Technician Interface
xmodem command, its parameters, and its options
How you use the asynchronous terminal program and
xmodem commands
together in procedures for transferring files to and from Bay Networks routers
About xmodem
Bay Networks routers support xmodem as a Technician Interface command and a
set of protocols for moving files between the Technician Interface console port of
a router and a remote workstation. The
xmodem command is based on the
Christensen protocol file transfer utility, V3.9, November 1990.
You determine the protocol for the task you need to perform by selecting the
appropriate syntax (parameters and options) for each
xmodem command. You
enter
xmodem commands directly at the command line prompt of either a UNIX
workstation or a 386/486 DOS workstation. (The procedural information you
need to enter and use
xmodem commands follows on page B-4.)
As a set of protocols,
xmodem includes the
XMODEM/CRC protocol
MODEM7 batch protocol
XMODEM-1K block protocol
YMODEM batch protocol
Of the four protocols available through
xmodem commands, you need to use only
the YMODEM batch protocol to transfer Bay Networks files between a remote
workstation and a router. For this reason, this section covers information on the
YMODEM protocol only. (For information on the other protocols supported by
xmodem commands, see “For More Information,” later in this appendix.)
Vista de página 291
1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 381 382

Comentários a estes Manuais

Sem comentários