Avaya Synchronous Net Modules in an ASN Platform Manual do Utilizador descarregar pdf (Página 31)

Replacing the Component Tray

Test Part Number BNX Software Version <x.x> Installing a Net Module11

Replacing the Component Tray

Before you replace the component tray, remove the alligator clip of the antistatic

strap from the chassis. Then remove the antistatic wrist strap from your wrist.

To replace the component tray:

1. Gently slide the tray into the chassis.

2. Use a Phillips screwdriver to tighten the two captive screws that fasten

the tray to the chassis (refer to Figure 1-1).

3. Reattach the cables to the proper connectors on the back panel.

See Chapter 2 for information about the LEDs on the net module.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Sem comentários

Avaya Synchronous Net Modules in an ASN Platform Manual do Utilizador Página 31