Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 122)

Configuring BayStack Remote Access

C-8

117341-B Rev. 00

Enter decimal value in seconds

for Hello Interval [10]:

The script suggests the following intervals:

Broadcast -- 10 seconds

Point-to-Point -- 15 seconds

NBMA -- 20 seconds

Point-to-Multipoint --10 seconds

Note:

This value must match all other

interfaces in the OSPF area for the

connection to occur.

Enter decimal value in seconds

for Router Dead Interval [40]:

The script suggests the following intervals:

Broadcast -- 40 seconds

Point-to-Point -- 60 seconds

NBMA -- 80 seconds

Point-to-Multipoint (STD) -- 40 seconds

Note:

This value must match all other

interfaces in the OSPF area for the

connection to occur.

Enter decimal value for Router

Priority [1]:

(For Broadcast, NBMA, or

Point-to-Multipoint)

Enter a router priority value. The lower the

value (above zero), the higher the priority.

Note:

If you set the router priority to zero

(0), the router is not eligible to become the

designated router on this network.

Enter decimal value in seconds

for Poll Interval [20]:

(For NBMA only)

Enter the maximum number of seconds

between the Hello packets that the router

sends to an inactive NBMA neighbor.

The script suggests a 20-second interval.

Enter IP address of neighbor

in dotted decimal notation or

enter q to quit:

(For NBMA only)

Enter addresses for all NBMA neighbors

you want the router to communicate with.

When you finish entering addresses, type

to quit.

Enter IP address of neighbor

in dotted decimal notation:

(For PPP only)

Enter addresses for the PPP neighbors

you want the router to communicate with.

OSPF Worksheet

(continued)

Prompt Options Your Response

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 137 138

Comentários a estes Manuais

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 122

Comentários a estes Manuais

Manuais e produtos relacionados com Routers Avaya Configuring BayStack Remote Access