Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 106)

Configuring BayStack Remote Access

B-12

117341-B Rev. 00

The possible settings for synchronous connectors are as follows:

•

EZ-Install (the default setting)

• The IP address, next-hop IP address, subnet mask, and WAN protocol (Bay

Networks Standard PPP or Frame Relay)

The possible settings for Ethernet connectors are as follows:

•

None (the default setting)

• The IP address with subnet mask and next-hop IP address (if you configured

one)

The possible settings for token ring connectors are as follows:

•

None (the default setting)

• The IP address with subnet mask, ring-speed option, and next-hop address (if

you configured one)

See Chapter 4 for instructions on using the

ifconfig and bconfig commands to

change the parameter settings.

Debugging the BootP Server

Debug the BootP server as follows:

Enter the following command at the UNIX command line:

bootpd -d -d&

The bootpd debugger tool reads the /etc/bootptab file and generates the

/etc/bootpd.dmp file. The /etc/bootpd.dmp file contains the portion of the

/etc/bootptab file that the bootpd debugger could read successfully. The

debugger displays messages such as the following:

[1] 12914

hostname:/etc> reading "/etc/bootptab"

read 19 entries from "/etc/bootptab"

dumped 19 entries to "/etc/bootpd.dump".

Compare the

bootptab

file with the

bootpd.dmp

file.

If the bootpd.dmp file is truncated or is otherwise different from the bootptab

file, BootPD may have encountered a syntax error. Find the inconsistency in

the two files.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 137 138

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 106