
Using the Technician Interface to Configure and Run Packet Capture
308656-14.00 Rev 00
B-57
An example of a hexadecimal display of a HSSI frame follows:
Pkt# 7 04/21/98 09:17:53.957 HPTP 52 Rx
00000000: 01 80 c2 00 00 00 00 00 a3 00 00 0c 00 26 42 42
00000010: 03 00 00 00 00 00 80 00 00 00 a3 00 00 0c 00 00
00000020: 00 00 80 00 00 00 a3 00 00 0c 80 01 00 00 14 00
00000030: 02 00 0f 00 6b 0d 00 00 00 00 00 00 00 00 00 00
ISDN
For each of the protocols supported over ISDN, the ISDN B channel works the
same way as the previously described serial media (see “Protocols Supported by
Synchronous, T1, E1, and MCT1 Media” on page B-52).
The ISDN D channel does not have a special data link offset. If you configure a
data link filter, set the offset to 0. The data link filter works the same way that the
MAC filter works.
An example of a hexadecimal display of an ISDN frame follows:
Pkt# 1 11/02/98 16:04:06.151 LAPD 26 Tx
00000000: 00 ad 00 00 08 01 01 05 a1 04 02 88 90 18 01 83
00000010: 70 08 80 32 32 34 30 33 38 37
Interpreting a Packet Capture Instance Number
When you create an instance of Packet Capture, you refer to the MIB to get the
numeric identifier, called a line number, of the Data Path channel. You then copy
the line number when creating the Packet Capture instance. The instructions are
provided in “Creating an Instance of Packet Capture
” on page B-7.
Site Manager automatically creates the line numbers when you use it to create a
configuration file. A line number is a 10-digit, decimal number that is unique for
each Data Path channel in a router.
Table B-3
indicates the structure of a line number or Packet Capture instance
number. The top row in the table is for the most significant digit, and the bottom
row is for the least significant digit.
Comentários a estes Manuais