Avaya Configuring IP, ARP, RIP, and OSPF Services Manual do Utilizador descarregar pdf (Página 297)

Site Manager Parameters

308627-14.00 Rev 00

A-47

Parameter: Metric Cost

Path: Configuration Manager > Protocols > IP > OSPF/MOSPF > Interfaces

Default: 1

Options: 1 to 65,535

Function: Indicates the cost of using this type of service on this interface. Nortel

Networks suggests the following values for this parameter: for 100 Mb/s or

greater, 1; for Ethernet/802.3, 10; for E1, 48; for T1, 65; for 64 Kb/s, 1562;

for 56 Kb/s, 1785; for 19.2 Kb/s, 5208; for 9.6 Kb/s, 10416. This parameter

allows you to configure preferred paths. If you do want to configure a

preferred path, allow that path to retain the default value of 1 or assign it a

relatively low metric cost. Then, assign the less preferred paths a higher

metric cost value.

Instructions: Either accept the default value, 1, or enter a larger number for a slower path

or a backup route.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.3.5.1.16

Parameter: Password

Path: Configuration Manager > Protocols > IP > OSPF/MOSPF > Interfaces

Default: None

Options: Any ASCII string up to eight characters long

Function: Specifies the password used for this area. You can specify a password up to

eight ASCII characters in length that will appear in the authentication field of

all OSPF packets across this interface. This parameter is valid only when the

Authentication Type parameter for the area is set to Simplepassword.

Instructions: Enter the appropriate password. All routers in the same area must either have

no authentication or have the same password.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.3.5.1.17

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 373 374

Sem comentários

Avaya Configuring IP, ARP, RIP, and OSPF Services Manual do Utilizador Página 297