Avaya Configuring APPN Services Manual do Utilizador descarregar pdf (Página 42)

Configuring APPN Services

2-2

308963-14.00 Rev 00

Enabling APPN over LLC2 Interfaces

When you configure APPN on LLC2 interfaces, such as Ethernet and token ring,

the Configuration Manager requests media access control (MAC) and service

access point (SAP) addresses. On synchronous interfaces where you are

configuring APPN over frame relay, the Configuration Manager requests a data

link connection identifier (DLCI) address and a SAP address.

To enable APPN on Ethernet, token ring, or Nortel Networks synchronous

interfaces using frame relay:

Select APPN from the Select Protocols window.

This menu appears after you select either a link or net module connector that

requires a wide area network (WAN) circuit. The Configuration Manager

automatically selects the LLC2 option.

Click on OK.

For frame relay and Ethernet networks, the “Use Source Route

Encapsulation?” dialog box appears (Figure 2-1

Click on Cancel if you are configuring standard LLC over Ethernet, or if

you are configuring frame relay using the RFC 1490 routing standard.

Caution:

The Technician Interface does not verify that the value you enter for

a parameter is valid. Entering an invalid value can corrupt your configuration.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 149 150

Sem comentários

Avaya Configuring APPN Services Manual do Utilizador Página 42