Avaya Configuring Data Compression Services Manual do Utilizador descarregar pdf (Página 69)

Data Compression Parameters

117352-C Rev. 00

A-9

Hi/fn LZS Interface Parameters

Use the following descriptions to set Hi/fn LZS compression parameters.

Parameter: Engine Type

Path: Configuration Manager > Protocols > WCP > Interfaces

Default: Inherit from Line

Options: Software

Hardware

Inherit from Line

Function: Specifies whether compression for this node will be software-based or

hardware-based.

Instructions: Select Inherit from Line if you want to accept the value in effect for the WCP

Engine Type line parameter. Otherwise, select Software to use software-based

compression or Hardware to use hardware-based compression.

You can use hardware compression with PPP and frame relay only. You can use

software compression with PPP, frame relay, or X.25.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.2.1.6

Parameter: Enable

Path: Configuration Manager > Protocols > Hi/fn LZS > Interfaces

Default: Enable

Options: Enable

Disable

Function: Enables or disables Hi/fn LZS compression on this interface.

Instructions: Site Manager automatically sets this parameter to Enable when you select Hi/fn

LZS as the compression protocol. If you want to temporarily disable Hi/fn LZS

rather than delete it from the router, set this parameter to Disable. To reenable

Hi/fn LZS, reset it to Enable.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.5.1.2

1 2 ... 64 65 66 67 68 69 70 71 72 73 74

Sem comentários

Avaya Configuring Data Compression Services Manual do Utilizador Página 69