Avaya BCM1000 Manual de Instalação descarregar pdf (Página 205)

Chapter 16 Replacing the hard disk 179

Installation and Maintenance Guide

5 Replace the cover on the BCM1000.

6 Restore the units to operation. Refer to “Restarting the system” on page 170.

7 Perform the procedure appropriate for the type of hard disk system you have:

• Single disk: Initialize the hard disk. Refer to “Initializing the hard disk (single-disk

system, BCM 2.5/2.5.1)” on page 179.

After the disk is initialized, restore your data from your backups. If you did not backup

your keycodes, re-enter them.

• Mirrored disks: The system automatically starts the mirroring process. Monitor the

progress of the mirroring task using the Mirroring diagnostics tool in the Unified Manager

(refer to “Controlling and monitoring mirroring operations” on page 196) or by using

Telnet.

The LEDs on the front of the RAID board indicate the current status of the board and the

hard disks. For more information, refer to “RAID board LEDs” on page 195.

Initializing the hard disk (single-disk system, BCM 2.5/2.5.1)

The BCM1000 is normally initialized at the factory. However, if you have to replace the hard drive

in a single-disk BCM1000, you must re-initialize the Business Communications Manager.

After you replace the hard disk and the system has booted up, perform the initialization as follows:

1 Make sure the Status LED on the BCM1000 is lit. This LED indicates that the Business

Communications Manager is operating correctly.

2 Attach the base unit and a computer through the serial port, as described in “Setting up the null

modem cable” on page 127.

3 Enter the terminal emulation program, as described in “Finding the configuration menus” on

page 128,

• If the hard disk does not require initialization, the main menu appears. Refer to Figure 83.

Figure 83 Main Menu screen

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 310 311

Sem comentários

Avaya BCM1000 Manual de Instalação Página 205