Avaya 1000 Series Video Conferencing Systems Guia de Configuração descarregar pdf (Página 17)

Configure H.323 video endpoints on Communication Manager 6.0

AVTS R 6.0 Quick Setup For feedback, use doc[email protected] August 2010

Configuring Polycom RMX Series Video Conferencing Bridge

Platform

Use this procedure to configure the Polycom RMX series video conferencing Bridge platform.

Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform

1. Enter change node-names ip to add an entry for the RMX system. Be sure to enter

the IP address of the IP board for the RMX system.

2Enter add trunk-group to add a two-way trunk group for the RMX system. Set the

following parameters:

● Group Type: ISDN

● Direction: Two-way

● Carrier Medium: H.323

● Service Type: Tie

3Enter add signaling-group to add a signaling group for the RMX system. Set the

following parameters:

● Group Type: H.323

● IP Video: y

● Priority Video. If you want all incoming calls to receive priority video

transmissions: y

● Trunk Group for Channel Selection to the two-way trunk group you added.

● Near-end Node Name. PROCR may be used for all systems and CLAN may be

used for systems with port networks.

● Near-end Listen Port: 1720

● LRQ Required: n

● RRQ Required: y

● Enable Layer 3 Test: n

● Far-end Node Name to the name you entered for the RMX system

● Far-end Listen Port: 1720

● Far-end Network Region

● Calls Share IP Signaling Connection: n

● Direct IP-IP Audio Connections: y

● IP Audio Hairpinning: n

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Sem comentários

Avaya 1000 Series Video Conferencing Systems Guia de Configuração Página 17