
Monitoring ATM Using the BCC show Command
303514-A Rev. 00
B-11
show dsx3 circuits
The
show dsx3 circuits
command displays information about the DSX3 circuits in the
configuration.
The output includes the following information:
Slot/<Module>/Conn The slot, module, and connector number of the DSX3 circuit.
Circuit The name of the circuit associated with this line.
Sec into Interval The number of seconds into the current 15-minute interval.
# of Intervals The number of complete 15-minute intervals. The value is 96 unless
the interface was brou
ht online within the last 24 hours. In that
case, the value is the number of complete 15-minute intervals since
the interface has been online.
Line Codin
The line codin
on this circuit. The line codin
options are:
•B3ZS
• HDB3
The line codin
specifies patterns of normal bits and bipolar
violations used to replace sequences of zero bits of a certain len
th.
Line Type Status The line status of the interface. The possible status values are:
•
NoAlarm
- no alarm present
•
RRAI
- receivin
yellow remote alarm indication
•
TRAI -
transmittin
yellow remote alarm indication
•
RAIS
- receivin
Alarm Indications Si
nal (AIS) failure state
•
TAIS
- transmittin
AIS failure state
•
LOF
- receivin
Loss of Frame (LOF) failure state
•
LOS
- receivin
Loss of Si
nal (LOS) failure state
•
Loopback
- loopin
the received si
nal
•
TestCode
- receivin
a test pattern
•
LowSignal
- low si
nal
Comentários a estes Manuais