
Installing the Data Module, Hardware Key, and Remote Maintenance Line
Chapter 3
Installing the Data Module 3-11
2. If the communications port connector on the PC has nine pins, do the
following:
— Plug the remaining end of the cable into the 25-pin portion of the
M25/F9 Adapter.
— Plug the 9-pin portion of the M25/F9 Adapter into the EIA
Connector Interface on the communications port. Tighten both
connector retaining screws.
If the communications port connector on the PC has 25 pins, you do not
need the M25/F9 Adapter—just plug the connector cable into your PC’s
25-pin port.
3. Tighten all retaining screws.
Comentários a estes Manuais