Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador descarregar pdf (Página 63)

Customizing SNMP

303542-A Rev 00

3-13

Configuring SNMP Community Managers

This section describes how to add and delete SNMP community members

(managers). It also describes how to configure managers to receive traps from the

SNMP agent.

Adding a Manager

After you have added a community name on the router and assigned access

privileges to it, you can add specific community members (called managers). You

can add more than one manager to a community.

By default, the IP address 0.0.0.0 is a manager in the public community.

Using the BCC

To add a manager to a community, navigate to the community prompt and enter:

manager address

ip_address

For example, the following command line creates a manager with an IP address of

2.2.2.4 and assigns it to the community Router1.

community/router1#

manager address 2.2.2.4

manager/router1/2.2.2.4#

Note:

When you add the first IP interface, Site Manager automatically creates

a read-write public community with a wildcard manager (0.0.0.0). For security

reasons, you should replace the public community and wildcard manager with

a unique community specifying a limited list of managers.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 145 146

Sem comentários

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador Página 63