Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador descarregar pdf (Página 15)

303542-A Rev 00

Preface

This guide describes how to configure Simple Network Management Protocol

(SNMP), Bootstrap Protocol (BootP), Dynamic Host Configuration Protocol

(DHCP), and Reverse Address Resolution Protocol (RARP) on Bay Networks

routers or BayStream

™

platforms.

You can use the Bay Command Console (BCC

™

) or Site Manager to configure

SNMP on a router; you must use Site Manager to configure BootP, DHCP, and

RARP services. In this guide, you will find instructions for using both the BCC

and Site Manager.

Before You Begin

Before using this guide with a new router, you must complete the following

procedures:

• Install the router (refer to the installation manual that came with your router).

• Connect the router to the network and create a pilot configuration file (see

Quick-Starting Routers, Configuring BayStack Remote Access, or Connecting

ASN Routers to a Network).

Make sure that you are running the latest version of Bay Networks BayRS

™

and

Site Manager software. For information about upgrading BayRS and Site

Manager, see the upgrading guide for your version of BayRS.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 145 146

Sem comentários

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador Página 15