Avaya Configuring Frame Relay Services Manual do Utilizador Página 175
- Página / 240
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Site Manager Parameters
117376-C Rev. 00
A-29
Parameter: Throughput
Path: Configuration Manager > Protocols > Frame Relay > Services > PVCs
Default: 0
Options: 0 to 2,147,483,647 b/s
Function: The rate in bits per second at which data travels over this VC when no
congestion is occurring. To enable traffic shaping, this parameter and the
Committed Burst parameter must be set to values greater than zero.
Instructions: Your carrier supplies the CIR or throughput value, which you enter in this
parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.9.2.1.18
Parameter: Congestion Control
Path: Configuration Manager > Protocols > Frame Relay > Services > PVCs
Default: Inherit
Options: Disable
|
Enable
|
Inherit
Function: Enables or disables congestion control on this interface.
Instructions: To activate congestion control, set to Enable. This value tells the router to drop
all traffic destined for a congested PVC until the congestion clears. To
deactivate congestion control, set to Disable. If you want the Congestion
Control setting for this PVC to match the setting you specify for the frame relay
Interface Congestion Control parameter, accept the default, Inherit.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.9.2.1.25
- Configuring 1
- Frame Relay Services 1
- Trademarks 2
- Restricted Rights Legend 2
- Statement of Conditions 2
- Contents 5
- 117376-C Rev. 00 10
- About This Guide 15
- Conventions 16
- Acronyms 17
- Bay Networks Customer Service 18
- How to Get Help 19
- Chapter 1 21
- Starting Frame Relay 21
- Configuring PVCs and SVCs 26
- Configuring an SVC 27
- Chapter 2 31
- Frame Relay Overview 31
- Introduction to Frame Relay 32
- Permanent Virtual Circuits 33
- Switched Virtual Circuits 33
- PVC and SVC Comparison 34
- Frame Relay Packets 35
- . Note, however 36
- Management Protocols 37
- BYS0037A 38
- LAPF Operational States 39
- SVC Signaling 41
- Call Setup 42
- Message Processing 43
- Frame Relay Service Records 44
- Frame Relay Access Modes 45
- Direct Access Mode 46
- Hybrid Access Mode 46
- Source Routing 48
- RFC 1490 48
- Address Resolution for PVCs 48
- Address Resolution for SVCs 49
- Traffic Control 50
- Data Compression 51
- Data Encryption 51
- Protocol Prioritization 51
- Traffic Shaping 53
- Quality of Service 55
- Traffic Shaping for SVCs 57
- Incoming 59
- Outgoing 59
- CIR Configuration Guidelines 60
- WCP and CIR Enforcement 60
- Oversubscribing the Interface 62
- X.213 Priority for SVCs 64
- Inactivity Timing for SVCs 64
- Multiline for PVCs 65
- PVC Pass-Through 67
- Frame Relay Dial Services 68
- Caution: 71
- Selecting a Management Type 72
- Selecting a DLCI Address Type 74
- Selecting Address Length 74
- Monitoring the Connection 76
- Polling Interval 77
- Full Enquiry Interval 77
- Customizing PVCs 81
- To delete PVCs: 87
- To move PVCs: 87
- Enabling Multicast 88
- Configuring PVC Pass-Through 90
- <integer> 100
- Enabling Compression for PVCs 102
- Using the BCC 103
- Using Site Manager 103
- Customizing SVCs 105
- For example: 107
- To delete service records: 107
- Call Screening and Blocking 108
- Disabling SVCs 112
- Disconnecting Active SVCs 114
- Setup Timer 121
- <value> 126
- (continued) 128
- Congestion Control 129
- Congestion Timer 130
- Congestion Counter 130
- Congestion Method 131
- To enable congestion control 134
- To enable traffic shaping 139
- To disable compression: 141
- To set X.213 priority value 143
- Deleting Frame Relay 144
- Customizing Frame Relay 145
- Appendix A 147
- Site Manager Parameters 147
- Figure A-2 148
- SVC LAPF Parameters 157
- SVC Signaling Parameters 163
- Parameters for PVCs 168
- PVC Service Record Parameters 172
- SVC Service Record Parameters 180
- SVC Options Parameters 186
- WHERE DOES THIS PARAMETER GO? 200
- Appendix B 201
- Table B-1. RIP Parameters 202
- Appendix C 209
- Monitoring Frame Relay Using 209
- BCC show Commands 209
- Commands for Frame Relay 210
- <option> 212
- <dlci> 215
- <name> 215
- ] [-service 216
- <multiline_name> 223
- <name> 228
Manuais e produtos relacionados com Redes Avaya Configuring Frame Relay Services
Redes Avaya BCM 2.5 Guia do Utilizador
(50 páginas)
(50 páginas)
Redes Avaya Glossary of Media Processing Server Series Terminology (Software Release 2.1) Manual do Utilizador
(124 páginas)
(124 páginas)
Redes Avaya BayRS Version 15.2.0.0 Aviso
(68 páginas)
(68 páginas)
Redes Avaya BCM200/400 Manual de Instalação
(386 páginas)
(386 páginas)
Redes Avaya X.25 Manual do Utilizador
(198 páginas)
(198 páginas)
Redes Avaya BCM450 Guia de Configuração
(11 páginas)
(11 páginas)
Redes Avaya X.25 Manual do Utilizador
(50 páginas)
(50 páginas)
Redes Avaya BayRS Version 15.1.0.0 Aviso
(72 páginas)
(72 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.197 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais