Avaya Business Secure Router 252 Configuration - Basics Manual do Utilizador descarregar pdf (Página 123)

Chapter 7 WAN screens 123

Nortel Business Secure Router 252 Configuration — Basics

RIP Direction RIP (Routing Information Protocol) allows a router to exchange

routing information with other routers. The RIP Direction field

controls the sending and receiving of RIP packets.

Choose Both, In Only or Out Only.

When set to Both or Out Only, the Business Secure Router

broadcasts its routing table periodically.

When set to Both or In Only, the Business Secure Router

incorporates RIP information that it receives.

Broadcast Dial Backup

Route

Select this check box to forward the backup route broadcasts to

the WAN.

Enable Multicast Select this check box to turn on IGMP (Internet Group Multicast

Protocol). IGMP is a network layer protocol used to establish

membership in a Multicast group—it is not used to carry user

data.

Multicast Version Select IGMP-v1 or IGMP-v2. IGMP version 2 (RFC 2236) is an

improvement over version 1 (RFC 1112) but IGMP version 1 is

still in wide use. For more information about interoperability

between IGMP version 2 and version 1, see sections 4 and 5 of

Internet Group Management Protocol

(RFC 2236).

Budget

Always On Select this check box to have the dial backup connection on all

of the time.

Configure Budget Select this check box to have the dial backup connection on

during the time that you select.

Allocated Budget Type the amount of time (in minutes) that the dial backup

connection can be used during the time configured in the

Period field. Set an amount that is less than the time period

configured in the Period field.

Period Type the time period (in hours) for how often the budget is

reset. For example, to allow calls to this remote node for a

maximum of 10 minutes every hour, set the Allocated Budget

to 10 (minutes) and the Period to 1 (hour).

Idle Timeout Type the number of seconds of idle time (when there is no

traffic from the Business Secure Router to the remote node) for

the Business Secure Router to wait before it automatically

disconnects the dial backup connection. This option applies

only when the Business Secure Router initiates the call. The

dial backup connection never times out if you set this field to 0

(it is the same as selecting Always On).

Call Schedule Sets Specify call schedule sets to use on the dial backup connection.

The call schedule sets must already be configured (see

Chapter 21, “Call scheduling screens,” on page 387).

Table 21 Dial Backup Setup

Label Description

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 459 460

Comentários a estes Manuais

Sem comentários

Avaya Business Secure Router 252 Configuration - Basics Manual do Utilizador Página 123

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Business Secure Router 252 Configuration - Basics