Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual do Utilizador descarregar pdf (Página 73)

Chapter 2 General CLI commands 71

Reference for the Business Policy Switch 2000 Command Line Interface

Setting Telnet access

You can also access the CLI through a Telnet session. To access the CLI remotely,

the management port must have an assigned IP address and remote access must be

enabled. You can log on to the switch using Telnet from a terminal that has access

to the BPS 2000.

To open a Telnet session from Device Manager, click on the Telnet icon on the

toolbar (Figure 15) or click Action > Telnet on the Device Manager toolbar.

Figure 15 Telnet icon on Device Manager toolbar

You can view the Telnet allowed IP addresses and settings, change the settings, or

disable the Telnet connection. This section covers the following topics:

• “show telnet-access command,” next

• “telnet-access command” on page 72

• “no telnet-access command” on page 73

• “default telnet-access command” on page 74

show telnet-access command

The show telnet-access command displays the current settings for Telnet

access. The syntax for the

show telnet-access command is:

show telnet-access

Note: Multiple users can access the CLI system simultaneously, through

the serial port, Telnet, and modems. The maximum number of

simultaneous users is four plus one each at the serial port for a total of 12

users on the stack. All users can configure simultaneously.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 232 233

Sem comentários

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual do Utilizador Página 73