Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual do Utilizador descarregar pdf (Página 116)

114 Chapter 2 General CLI commands

212160-B

default rate-limit command

The default rate-limit command restores the rate-limiting value for the

specified port to the default setting. The syntax for the

default rate-limit

command is:

default rate-limit [port <portlist>]

The default rate-limit command is in the config-if command mode.

Table 56 describes the parameters and variables for the

default rate-limit

command.

Table 56 default rate-limit command parameters and variables

Parameters and

variables

Description

port <portlist> Specifies the port numbers to reset rate-limiting to factory default.

Enter the port numbers you want to set rate-limiting to default on.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 232 233

Sem comentários

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual do Utilizador Página 116