Avaya BCM 2.0 Programming Guia do Utilizador descarregar pdf (Página 245)

Configuring Digital Private Network Signalling System1 245

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

Setting Diversion

You set Diversion for DPNSS in the same way as Call Forward, see Capabilities on

page 98. You will need to enter the end DN when prompted. You may also need to

include the DPNSS 1 routing number.

Redirection

Redirection is a DPNSS 1 feature similar to Enterprise Edge Transfer Callback.

Redirection lets a call awaiting connection, or re-connection, be redirected by the

originating party to an alternate destination after a time-out period. Failed calls can

also be redirected. Priority calls are not redirected.

Note: The address to redirect depends on the history of the call. Calls that have

been transferred could be redirected to the party that transferred them. In all

other cases, the address to redirect is the one registered at the PBX

originating the redirection.

Note: Enterprise Edge does not support the redirection of Enterprise Edge

originated calls, even over DPNSS 1.

The Diversion on No Reply feature takes precedence over Redirection.

Restrictions by set type

Redirection is indicated differently on different types oftelephone sets:

• For sets without displays the “#” key acts as MORE and the “*” key acts as VIEW.

• ATA—Is not supported.

• ISDN—All variations of the feature are supported on ISDN sets.

• Portables—All variations of the feature are supported on portable sets.

• DNA—Is not supported.

Setting Redirection

The timer used for the network Callback Feature applies for redirection.

Executive Intrusion

Executive Intrusion (EI) is a DPNSS 1 feature that allows an operator, or other

calling party, to intrude on a line when it is busy. This feature might be required, for

example, in times of emergency or to make an important announcement when the

recipient is on another call.

EI is similar in functionality to Enterprise Edge Priority Call. It is, however, a

receive-only feature on Enterprise Edge sets; that is, EI cannot be initiated from an

Enterprise Edge set. The originating caller wouldbe on another PBXon theDPNSS

1network.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 445 446

Sem comentários

Avaya BCM 2.0 Programming Guia do Utilizador Página 245