Avaya B5800 Manual do Utilizador descarregar pdf (Página 63)

Tools required

• 5mm Flat-blade screwdriver

• Anti-static wrist strap and ground point

Installing a legacy carrier card

Procedure

1. Check that correct cards have been supplied.

2. Ensure that you are wearing an anti-static wrist strap connected to a suitable ground

point.

3. On the carrier card identify the position of the jumper block and stand-off pillar holes

for the IP400 card.

The peg holes are labeled as VCM or TRUNK.

4. If fitting an IP400 trunk card, identify which of the plastic snap-off panels on the front

of the carrier card need to be removed to allow the trunk cable connections.

5. Carefully remove those panels.

6. Fit the stand-off pillars to the legacy carrier card.

7. Using minimal force and checking that the pins are correctly located, push the IP400

card onto its jumper and the stand-off pillars.

Base card insertion

Having prepared each base card by adding the trunk daughter cards or legacy carrier cards,

the base card can be inserted into the control unit.

Base and trunk card installation

Implementing the Avaya B5800 Branch Gateway for an Avaya Aura

Configuration October 2012 63

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 313 314

Sem comentários

Avaya B5800 Manual do Utilizador Página 63