Avaya B5800 Manual do Utilizador descarregar pdf (Página 53)

Chapter 4: Hardware and software

installation

This chapter addresses new installations. If you are upgrading a B5800 Branch Gateway system, see

Upgrading an R6.1 system to R6.2 on page 89 or Upgrading an R6.2 system with an R6.2 service

pack on page 97.

All hardware components should be turned off while they are installed and connected. Once the installation

is complete, the system is turned on. The control unit will then upgrade all of the connected components,

including phones, to the appropriate level of firmware. In addition, when the system is turned on, it should

not be connected to the customer's data network. This ensures that the control unit will default to known

default IP address settings (unless you have pre-loaded the System SD card with a configuration file with

different settings).

B5800 Branch Gateway R6.2 provides the B5800 Branch Gateway Initial Installation utility. This utility

provides a default configuration and security settings that minimize initial installation activities and

maximize security. The system must be configured with the default settings before the system can be

administered by Avaya Aura

System Manager. This utility is used for new installations and after an R6.1

to R6.2 upgrade to enable System Manager administration of the B5800 Branch Gateway. For more

information, see

Using the Initial Installation Utility on page 121.

Installation checklist

Use this checklist to monitor your progress as you install a B5800 Branch Gateway system.

Description Section

1 Review the prerequisites. See Prerequisites on page 35.

2 Review the Installation

requirements.

See Installation requirements on page 41.

3 Review the required tools and

equipment.

See Tools and equipment required on

page 54.

4 Unpack the equipment. See Unpacking equipment on page 55.

5 If you want to pre-configure the

system, there are several tasks

you can perform to configure the

See SD card preparation on page 56.

Implementing the Avaya B5800 Branch Gateway for an Avaya Aura

Configuration October 2012 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 313 314

Sem comentários

Avaya B5800 Manual do Utilizador Página 53