Avaya Hardware Compression Net Modules in ASN Platforms Manual do Utilizador descarregar pdf (Página 27)

Installing a Net Module

115374-A Rev. A

1-5

Removing Filler Brackets

Filler brackets cover empty ASN net module positions and the openings above

positions 1 and 3 (Figure

1-2). When you install a net module, you must remove

the ﬁller brackets not only from the position in which you want to install the net

module, but also from the openings above positions 1 and 3.

To remove a ﬁller bracket, grasp its top edges. Then lift the bracket up and toward

the front of the tray to release the metal tabs.

Figure 1-2. Locating Net Modules and Filler Brackets

Removing a Net Module

Read this section if a net module already occupies the slot you want to use. To

remove a module from position 2 or 4 (Figure

1-2), you must ﬁrst remove the

ﬁller bracket and net module (if any) above it. See the previous section,

“Remo

ving Filler Brackets.”

Note: This manual refers to the end of the component tray where the net

module ports are exposed as the “back end” of the tray. To perform

maintenance tasks on the ASN components, you face the back end of the tray.

Caution: Do not touch any components or boards in the ASN until you have

attached the antistatic wrist strap.

Net module filler

bracket

Expansion

filler bracket

DCD

XMT/RCV

ETHERNET

34000

DCD

SYNC

34001

Net module

positions 1 and 2

Net module

positions 3 and 4

DCD

SYNC

34001

ASN0042A

CONSOLE

SPEX

SLOT

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comentários a estes Manuais

Sem comentários

Avaya Hardware Compression Net Modules in ASN Platforms Manual do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com não Avaya Hardware Compression Net Modules in ASN Platforms