Avaya Configuring Data Compression Services Manual do Utilizador descarregar pdf (Página 69)

Data Compression Parameters

117352-B Rev. 00

A-9

PPP Interface Parameters for Compression

There are two PPP interface parameters for data compression. You can find them

by scrolling through the PPP Interfaces List window. For more information about

PPP, refer to Configuring PPP Services.

The PPP parameters for compression are as follows:

Parameter: CCP Type

Path: Configuration Manager > Protocols > PPP > Interfaces

Default: CCP

Options: ILCCP

CCP

Function: Specifies the compression control protocol the router uses for this interface.

Instructions: Accept the default, CCP, if you select Stac LZS as the compression protocol, or

if you select WCP as the compression protocol and you set the PPP Mode

parameter to multilink. Using CCP as the compression type means that the

router negotiates compression above the multilink bundle.

Select ILCCP if you are configuring a new circuit and you set the PPP Mode

parameter to multilink, and the remote router is using software prior to Version

12.10. Using ILCCP as the compression type means that the router will

negotiate compression below the multilink bundle.

If you have a Bay Networks 12.10 router using an older configuration file, the

routers negotiate WCP below the multilink bundle by default. You can change

this to CCP for the routers at both ends of the link to negotiate WCP above the

multilink bundle.

MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.71

1 2 ... 64 65 66 67 68 69 70 71 72

Sem comentários

Avaya Configuring Data Compression Services Manual do Utilizador Página 69