Avaya Configuring Data Compression Services Manual do Utilizador descarregar pdf (Página 23)

Starting Compression

308616-14.00 Rev 00

1-5

Configuring Software Compression

Software compression works on all router platforms and all serial interfaces. After

you open a configuration file, you can enable compression using either the BCC

or Site Manager.

Using the BCC

To configure software compression using the BCC, proceed to the following

sections:

• Enabling WCP Compression for PPP

on page 1-5

• Enabling Hi/fn LZS Compression for PPP on page 1-7

• Enabling Compression for Frame Relay on page 1-11

Enabling WCP Compression for PPP

This section provides examples of how to add WCP software compression for PPP

services in several different contexts: on a logical line, on a back-up line, on a

demand-circuit.

Adding WCP to PPP over a Logical Line

To add WCP compression for PPP services on a logical line for a BN router,

configure a logical line, navigate to the ppp prompt (for example,

box

;

mct1 2/1

;

logical-line to-tampa

;

ppp

), and enter:

wcp

Example:

box#

mct1 2/1

mct1/2/1#

logical-line to-tampa

logical-line/to-tampa#

ppp

ppp/to-tampa#

wcp

wcp/to-tampa#

Note:

Enabling WCP adds five bytes to the frame’s header. In most cases, this

has no effect on your data and there is no need for you to adjust the default

configuration. If you want to increase the maximum transmission unit (MTU)

to avoid fragmenting or dropping large packets, refer to the manual for the

WAN protocol you are using.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 107 108

Comentários a estes Manuais

Sem comentários

Avaya Configuring Data Compression Services Manual do Utilizador Página 23

Comentários a estes Manuais

Manuais e produtos relacionados com não Avaya Configuring Data Compression Services