Avaya Using Technician Interface Software Manual do Utilizador Página 314

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 313
Using Technician Interface Software
C-20
To define by severity levels the event messages you want Syslog to select
and forward to a specific remote host, enter the following:
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSevMask.
<host_IP_address>.<entity_code>.<filter_index>
<fwitd>”
$: commit
c. To also define by slot number(s) the event messages you want Syslog
to select and forward to a specific remote host, enter the following:
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowBnd.
<host_IP_address>.<entity_code>.<filter_index>
<0 – 14>
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrSlotLowUpp.
<host_IP_address>.<entity_code>.<filter_index>
<0 – 14>
$: commit
3. Define how router event message severity levels and UNIX system error
levels map to one another.
In most cases, you accept the default mapping and go to Task 7. Otherwise,
continue with the following instructions to customize the message mapping.
Enter at the Technician Interface prompt the command line(s) appropriate for
the message mapping(s) you want to change:
a. Change router FAULT message mapping, as follows:
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrFaultMap.
<host_IP_address>
.
<entity_code>
.
<filter_index>
<1 – 8>
The default value of wfSyslogEntFltrFaultMap is 3, mapping router
FAULT level messages to UNIX system level CRIT messages.
Note: Although the valid range for the slot lower and upper boundaries is 0 to
14, specify only values within the range of actual slot numbers for the model of
router you are configuring. Otherwise, the filter will not transition to an active
state.
Vista de página 313
1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 351 352

Comentários a estes Manuais

Sem comentários