Avaya Bay Command Console Manual do Utilizador descarregar pdf (Página 56)

Using the Bay Command Console (BCC)

2-28

117383-D Rev 00

• To display every -

filter

and

filter_argument

available for a specific show

command, insert the

? where filters and their arguments would appear after

any keywords in the command line.

Example:

bcc>

show frame-relay congestion ?

show frame-relay congestion [-state <arg>][-interface <arg>][-service

<arg>] [-dlci <arg>]

Usage Notes:

• Use the show command to display routing, configuration, interface, and

statistical data from the Management Information Base (MIB). The type and

amount of data displayed depends on the specific protocol, network service,

and/or filtered view you want to see.

• Use lowercase for all show commands.

•

pattern

means that you can use wildcard searching with the * and ? characters.

Use

* to find a string of any characters of any length. Use ? to designate any

character in a specific position of the search string. For example, to locate all

networks whose addresses begin with 29, enter:

string 29*

This pattern will locate the addresses 2901456 and 2967. Or if you have a set

of names that begin and end with the same characters but have different

characters in the middle, such as xxx1.yy, xxx2.yy and so on, you can enter the

search pattern

xxx

to locate them.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 139 140

Sem comentários

Avaya Bay Command Console Manual do Utilizador Página 56