Avaya Configuring RADIUS Manual do Utilizador descarregar pdf (Página 21)

Starting RADIUS

303538-A Rev 00

1-5

Select Authentication, Accounting, or Both to enable both services.

If the router is already using a slot for dial-on-demand, dial backup, or

bandwidth-on-demand service, you cannot select this slot for authentication.

This restriction does not apply if you configured a slot with a demand circuit

group that uses only one demand pool. There is no restriction for configuring

RADIUS accounting.

For RADIUS authentication, select the connectors that you want to serve

as RADIUS interfaces. This is not required for RADIUS accounting.

• To configure a modem line for RADIUS, click on a COM connector.

(To configure an ISDN line for RADIUS, go to page 1-7

Site Manager displays the Choose WAN Serial Interface Type window

(Figure 1-4)

Figure 1-4. Choose WAN Serial Interface Type Window

On the BLN and BCN, the Choose WAN Serial Interface Type window

appears only for ports on an Octal Sync Link Module. For all other

modules, Site Manager displays the Sync Line Media Type window

(Figure 1-5).

If you are using synchronous PPP for your dial connections, accept the

default, Sync, for the WAN Serial Interface Type parameter. Site Manager

displays the Sync Line Media Type window (Figure 1-5)

. If you plan to

use Asynchronous PPP for your dial connections, select Async. Site

Manager displays the Async Line Media Type window (Figure 1-6).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Sem comentários

Avaya Configuring RADIUS Manual do Utilizador Página 21