Avaya Configuring Bridging Services Manual do Utilizador descarregar pdf (Página 229)

Configuring Source Routing Bridge Services Using the BCC

117351-B Rev. 00

7-21

Setting the WAN Broadcast Address

You can set the data link connection identifier (DLCI) number this interface uses

when it sends broadcast frames over frame relay. To set the WAN broadcast

address, navigate to the interface srb prompt and enter:

wan-broadcast-dlci

<dlci_number>

dlci_number

is any valid frame relay DLCI number.

For example, the following command sets the WAN broadcast address to 1115:

srb/ethernet/2/1#

wan-broadcast-dlci 1115

Setting the Encapsulation Format

You can specify Bay Networks proprietary encapsulation format or standard

encapsulation format.

To run source routing over a frame relay network:

• If the router, running software Version 8 or later, communicates with a

third-party router that supports RFC 1490, and you configured both routers to

run source routing over frame relay, select standard for RFC 1490 standard

frame relay encapsulation.

• If the router, running software Version 8 or later, communicates with a Version

5 Bay Networks router, and you configured both routers to run source routing

over frame relay, accept the default, proprietary.

• If the Version 8 router communicates with a Version 7 Bay Networks router,

and you configured both routers to run source routing over frame relay, select

standard.

• If the router, running software Version 8 or later, communicates with another

Version 8 router, and you configured both routers to run source routing over

frame relay, you can select either proprietary or standard; however, you must

set the same encapsulation format for both routers.

If you want to bridge between source routing token ring and FDDI end stations:

• If the router, running software Version 8 or later, connects token ring end

stations to FDDI end stations, select standard for standard native

encapsulation.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 259 260

Sem comentários

Avaya Configuring Bridging Services Manual do Utilizador Página 229