Avaya Router Guia de Início Rápido descarregar pdf (Página 48)

Quick-Starting Routers

4-4

308654-14.00 Rev 00

If the ping test is not successful, the cause may be network problems that have

nothing to do with the Quick-Start installation. To troubleshoot the network

problems, you can leave the ping test by typing

Q. See “Quick-Start

Troubleshooting” on page 4-4 for more information.

If the ping test is successful, the initial IP interface is enabled and the script

displays this message:

Quick-Start Installation Completed

The Technician Interface prompt appears.

You now have a configuration file named startup.cfg on the router volume that

contains your initial interface. The configuration is active in the router’s memory.

Nortel Networks recommends that you immediately secure your router to prevent

unauthorized access. See Chapter 7, “Securing the Router,” for information.

Quick-Start Troubleshooting

If the router cannot ping the workstation during the Quick-Start procedure, check

the following:

• If the router was able to ping its own interface, and the script prompted you

for the interface of the workstation, you probably have a successful

installation. To be sure, continue with the remaining checks.

• Check the physical connections.

• If the workstation is a PC, a supported TCP/IP stack must be running for a

successful ping. See Chapter 8, “Installing Site Manager on a PC,” for

information about TCP/IP stacks, adapters, and drivers.

• Verify the IP address of the router. Enter the

show ip circuits command at the

Technician Interface prompt to make sure that the physical interface is up and

that the IP address is correct. For more information about the

show command,

see Using Technician Interface Scripts.

Caution:

Do not reboot the router after successfully completing the

Quick-Start procedure. By default, the router reboots with the file named

config, not the startup.cfg file that you just created. See Chapter 6,

“Completing the Router Configuration,” for instructions on testing the

startup.cfg file before you save it as config.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 131 132

Sem comentários

Avaya Router Guia de Início Rápido Página 48