Avaya Configuring RADIUS Manual do Utilizador descarregar pdf (Página 105)

Configuring RADIUS with SecurID

308640-15.1 Rev 00

E-3

Accept the remaining default parameter values for the RADIUS client or

modify them to customize the RADIUS client’s configuration.

Navigate to the top-level RADIUS prompt.

radius-client/3# back

radius#

Specify the IP address for the ACE/Server.

radius# radius-server address <server_address>

server_address

specifies the IP address of the ACE/Server.

For example, the following command configures the ACE/Server for

authentication at the IP address 192.32.10.1:

radius# radius-server address 192.32.10.1

radius-server/192.32.10.1#

Change the server response time.

By default, the RADIUS client waits 3 seconds for a server to respond to an

authentication request. The ACE/Server, however, requires additional time to

respond to authentication requests. Therefore, you must increase the response

time to a minimum of 10 seconds. If your network accommodates a high level

of traffic, you may need to increase the response time to 30 seconds.

To increase the response time, enter:

response-timeout <value>

value

specifies the response time in seconds.

For example, the following command configures the RADIUS client to wait

10 seconds before retransmitting a request to the ACE/Server:

radius-server/192.32.1.100#

response-timeout 10

Set the authentication server type.

You must designate one RADIUS server as the primary server for

authentication. To specify a primary server, enter:

authentication-server-type {primary

alternate}

For example, the following command configures the RADIUS server

192.32.1.100 as the primary server:

radius-server/192.32.1.100#

authentication-server-type primary

10.

Modify the primary server’s password.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 115 116

Sem comentários

Avaya Configuring RADIUS Manual do Utilizador Página 105