Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual do Utilizador descarregar pdf (Página 80)

Configuring Ethernet, FDDI, and Token Ring Services

5-8

305259-A Rev 00

Implementation Considerations

Before you configure 802.1Q tagging on a router, note the following

considerations:

• 802.1Q tagging is supported only on 100BASE-T interfaces; it is not

supported on other LAN interfaces.

• 802.1Q tagging cannot be used to extend a VLAN across multiple devices.

• The VLAN type (port-based, protocol-based, address-based, and so on) is

ignored by the router.

Adding a Tagged Circuit to an Unconfigured 100BASE-T

Interface

The following procedure describes how to add an 802.1Q tagged circuit to a

previously unconfigured 100BASE-T interface. This procedure assumes that you

are configuring the 802.1Q tagged circuit for IP routing. To enable other routing

protocols on an 802.1Q tagged circuit, see the appropriate guide for that protocol.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on a 100BASE-T connector.

The Add Circuit window opens.

2. Click on

. The Select Protocols window opens.

3. Choose

VLAN

, then click on

. The Edit VLAN Interface Parameters

window opens.

4. Click on

Add

. The TAG1Q Parameters window opens.

5. Set the following parameters:

• VLAN Name

• Global VLAN Id

Click on

Help

or see the parameter

descriptions beginning on page A-15

6. Click on

. The Edit VLAN Interface Parameters

window opens. Note that 802.1Q tagged

circuits are displayed with a V

extension.

(continued)

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 135 136

Comentários a estes Manuais

Sem comentários

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual do Utilizador Página 80

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring Ethernet, FDDI, and Token Ring Services