
Configuring AppleTalk Services
4-22 114048 Rev. A
3. Enter the appropriate IP address (using dotted decimal notation) in the
Local IP Address field.
4. Click on OK to exit the window and save your changes when you are
finished.
Parameter: Enable
Default: Enable
Options: Enable
| Disable
Function: Enables or disables AURP on the router.
Instructions: Set to Disable if you want to globally disable AURP.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8#2
Parameter: Local IP Address
Default: None
Options: Any valid 32-bit IP address using dotted decimal notation; for example,
205.1.8.2
Function: Identifies an IP interface on the router. This is the IP interface used for
AURP.
Instructions: Enter the IP address of the interface on this router that AURP should use.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8#5
Editing AURP Interface Parameters
You use the AURP interface parameters to configure an AURP connection. To edit
an AURP connection, begin at the Configuration Manager window and proceed as
follows:
1. Select Protocols > AppleTalk > AURP > Interfaces.
The AT AURP Interface Configuration window appears (Figure
4-9).
Comentários a estes Manuais