Avaya BCM First Time Guia de Instalação descarregar pdf (Página 5)

Installation overview / 5

P0993238 Issue 01

Installation overview

There are three main steps required to install the Business Communications Manager:

1. Install the Business Communications Manager hardware.

For more information refer to Installing the Business Communications Manager hardware

on page 5.

2. Connect to the Business Communications Manager one of the following two methods.

• Connect using a network interface card.

For more information, refer to Connecting using the network interface card on page 6.

• Connect using a serial port.

For more information, refer to Changing the default IP address on page 11.

3. Initialize the Business Communications Manager software using the Quick Start Wizard.

For more information refer to Using the Quick Start wizard for initial configuration on

page 7.

Installing the Business Communications Manager hardware

1. Choose a location for the BCM. Make sure this location meets the requirements listed in

the Installation Preparation Checklist section of the Business Communications

Manager 3.0 Installation and Maintenance Guide.

Note: If your system includes an Expansion Unit, you should install the Expansion Unit

before you connect the power, telephony or data network wiring. For more

information about installing the Expansion Unit, refer to the Business

Communications Manager 3.0 Installation and Maintenance Guide.

2. If you are mounting the BCM in a rack, attach the rack mount brackets to the BCM.

If you are mounting the BCM on a wall, attach the wall mount brackets to the BCM.

If you are mounting the BCM on a table, or other flat, stable surface, attach the four

rubber feet to the BCM.

3. Mount the BCM in the rack, on the wall or on the table.

4. Set the DIP switches on all of the media bay modules you are going to install in the

BCM.

5. Remove the cover plates from the media bays you are going to use.

6. Insert the media bay modules into the BCM.

Note: The DTM and DDI MUX media bay modules must be installed in the BCM200 or

BCM400 main chassis, not the Expansion Unit. Problems can occur if these type

of media bay modules are installed in the Expansion Unit.

7. If this Business Communications Manager system includes an optional WAN card, install

the WAN card in the BCM. For instructions on how to install the WAN card, refer to

Installing a WAN card on page 9.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Sem comentários

Avaya BCM First Time Guia de Instalação Página 5