Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual do Utilizador descarregar pdf (Página 99)

Chapter 2 General CLI commands 99

Reference for the Business Policy Switch 2000 Command Line Interface

default rate-limit command

The default rate-limit command restores the rate-limiting value for the

specified port to the default setting. The syntax for the

default rate-limit

command is:

default rate-limit [port <portnum>]

The default rate-limit command is in the config-if command mode.

Table 47 describes the parameters and variables for the

default rate-limit

command.

Table 47 default rate-limit command parameters and variables

Parameters and

variables

Description

port <portnum> Specifies the port number to reset rate-limiting to factory default.

Enter the port number you want to set rate-limiting to default on.

Note: If you omit this parameter, the system uses the port number

you specified in the

interface command.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 199 200

Sem comentários

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual do Utilizador Página 99