Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Aviso descarregar pdf (Página 26)

215148-D

The copy running-config command is in the privExec command mode.

Table 5 describes the parameters and variables for the copy running-config

command.

Figure 2 displays sample output from the copy running-config command.

Figure 2 copy running-config command output

configure network command

The configure network command loads the ASCII configuration file from an

external TFTP server. The syntax for the

configure network command is:

configure network [address <A.B.C.D>] [filename <WORD>]

Note: The copy config command will copy a binary configuration

file to the TFTP server. To store the configuration as an ASCII file, you

must use the

copy running-config command.

Table 5 copy running-config command parameters and variables

Parameters and variables Description

address <A.B.C.D> Specifies the TFTP server IP address; enter in

dotted-decimal notation.

filename <WORD> Specifies the name of the existing ASCII configuration file

on the TFTP server. This file must be read/write enabled.

BS470#copy running-config tftp address 134.177.118.56 filename config.txt

%Contacting TFTP host: 134.177.118.56.

%ACG Configuration file successfully written.

BS470#

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

Sem comentários

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 Aviso Página 26