Avaya Auto Voice VLAN Detection and Configuration SMB Business Ethernet Switch 50 Manual do Utilizador descarregar pdf (Página 10)

Technical Note: Auto Voice VLAN Detection and Configuration

Step 4: Enable Per-Port Voice VLAN Detection

The final configuration step is to enable voice VLAN detection on the ports in which IP phones may connect

to. While both the BES50FE and BES50GE switch need to enable the same “Voice VLAN Mode” attribute,

the WebUI panels of these two switches are slightly different.

The following screenshot illustrates the configuration procedure for BES50GE.

• From the WebUI, navigate to the Applications > Auto Device Detection > Voice VLAN > Port

Configuration panel.

• Move to the row corresponding to the target Ethernet port. E.g. for port 5, move to the row labeled “5”.

• From the pull down menu of the Voice VLAN Mode, select Auto mode.

• Select and press the Submit button.

The following screenshot illustrates the configuration procedure for BES50FE.

• From the WebUI, navigate to the Applications > Auto Device Detection > Voice VLAN > Port

Configuration panel.

• Move to the row corresponding to the target Ethernet port. E.g. for port 5, move to the row labeled “5”.

• From the pull down menu of the Voice VLAN Mode, select Auto mode.

• Under the Discovery Protocol attribute, select the checkbox labeled 802.1AB.

• Select and press the Submit button.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sem comentários

Avaya Auto Voice VLAN Detection and Configuration SMB Business Ethernet Switch 50 Manual do Utilizador Página 10