Avaya T3/E3 Manual do Utilizador

Part No. 313889-A Rev 00September 2001600 Technology Park DriveBillerica, MA 01821-4130ATM T3/E3 PMC Module Supplement

313889-A Rev 00xiTablesTable 1-1. Accessories in the Passport 5430 Shipping Container ...1-2Table 1-2. ATM T3 or E3 Interface

313889-A Rev 00xiii PrefaceThe Nortel Networks* ATM T3/E3 PMC module provides an interface to support unchannelized T3 or E3 operation for ATM applica

ATM T3/E3 PMC Module Supplementxiv313889-A Rev 00Acronyms This guide uses the following acronyms:Hard-Copy Technical ManualsYou can print selected tec

Preface313889-A Rev 00xv How to Get HelpIf you purchased a service contract for your Nortel Networks product from a distributor or authorized reseller

313889-A Rev 001-1 Chapter 1Using the ATM T3/E3 PMC ModuleThis document supplements Installing and Operating the Passport 5430 Multiservice Access Swi

ATM T3/E3 PMC Module Supplement1-2313889-A Rev 00Verifying Shipment ContentsIf you have just received the T3/E3 PMC module, make sure your shipment is

Using the ATM T3/E3 PMC Module313889-A Rev 001-3 Figure 1-1. Shipping ContentsPreparing to Install the ATM T3/E3 PMC ModuleBefore beginning the instal

ii313889-A Rev 00 Copyright © 2001 Nortel NetworksAll rights reserved. September 2001.The information in this document is subject to change without no

ATM T3/E3 PMC Module Supplement1-4313889-A Rev 00Tools and CablesTo install the ATM T3/D3 PMC module into the Passport 5430 you need a Phillips screwd

Using the ATM T3/E3 PMC Module313889-A Rev 001-5 Table 1-2 shows the jumper pins that are associated with the receiving and transmitting interfaces. T

ATM T3/E3 PMC Module Supplement1-6313889-A Rev 00Removing a Jumper HeadAn interface is AC coupled if there is no jumper head on the associated jumper

Using the ATM T3/E3 PMC Module313889-A Rev 001-7 To install the PMC module on the system processor card:1.Attach an antistatic wrist strap.2.Holding t

ATM T3/E3 PMC Module Supplement1-8313889-A Rev 004.Insert and tighten the four screws to secure the PMC module to the system processor card (Figure 1-

Using the ATM T3/E3 PMC Module313889-A Rev 001-9 Attaching CablesThe ATM T3/E3 PMC module provides two T3 or E3 interfaces, as described in Table 1-3.

ATM T3/E3 PMC Module Supplement1-10313889-A Rev 002.Connect the other end of the adapter to the 75 ohm BNC cable.3.Connect the BNC cable to the T3/E3

Using the ATM T3/E3 PMC Module313889-A Rev 001-11 Completing the Software ConfigurationOnce you have successfully installed the ATM T3/E3 PMC module,

313889-A Rev 00A-1 Appendix ACables and Interface SpecificationsPortsThe T3/E3 interface consists of two 75 ohm mini-SMB connectors for a separate inp

313889-A Rev 00iiiTo maintain compliance with FCC radio frequency emission limits, shielded cables are required to connect equipment to other Class A

ATM T3/E3 PMC Module SupplementA-2313889-A Rev 00Environmental SpecificationsThe environmental requirements for the ATM T3/E3 PMC module are as follow

iv313889-A Rev 00Nortel Networks Inc. Software License AgreementThis Software License Agreement (“License Agreement”) is between you, the end-user (“

313889-A Rev 00v4. Generala) If Customer is the United States Government, the following paragraph shall apply: All Nortel Networks Software available

313889-A Rev 00viiContents PrefaceBefore You Begin ...

313889-A Rev 00ixFiguresFigure 1-1. Shipping Contents .....................1-3Figure 1-