Avaya B5800 Manual do Utilizador descarregar pdf (Página 315)

The difference between the two values needs to be greater than or equal to the

desired number of simultaneous SIP trunk connections.

Configuring trunk-to-trunk transfer

Use this procedure to configure Communication Manager to allow trunk-to-trunk transfers.

1. Enter the change system-parameters features command.

2. In the Trunk-to-Trunk Transfer field, enter the appropriate number.

Note:

If the Trunk-to-Trunk Transfer field is set to all, this will enable all trunk-to-trunk

transfers on a system-wide basis.

Note that this feature poses significant security risk, and must be used with

caution. As an alternative, the trunk-to-trunk feature can be implemented using

Class Of Restriction or Class Of Service levels.

Configuring IP node names

Use this procedure to add Avaya Aura

Session Manager as an IP node.

1. Enter the change node-names ip command.

2. In the Name field, enter a name for this IP node.

3. In the IP Address field, enter the IP address of the Avaya Aura

Session Manager's

Security Module (SM-100) interface.

Configuring IP codec set

If necessary, configure an IP codec set for use with SIP calls.

1. Enter the change ip-codec-set n command, where n is the codec set number to

be used.

2. In the Audio Codec field, enter the desired audio codec type.

3. Retain the default values for the remaining fields.

Configuring trunk-to-trunk transfer

Implementing the Avaya B5800 Branch Gateway November 2011 315

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 341 342

Sem comentários

Avaya B5800 Manual do Utilizador Página 315