
Editing AppleTalk Parameters
117366-A Rev. A 4-17
The AppleTalk Zone Filter Configuration window now lists the zone filter you
added. The zone filter type automatically defaults to Exclude. See the next
section, “Editing the Zone F
ilter Type,” for instructions on changing this
parameter.
6. Click on Done to save your changes and exit the window.
Editing the Zone Filter Type
A zone filter can be one of two types, Exclude or Include. You can configure a
zone filter list to partially deny or allow zones, using the 5.X Exclude and 5.X
Include options.
When you configure an exclude zone filter list, the interface advertises that it can
reach all zones except those specified on the list. This type of filter is useful if you
want to filter out only a few of the zones that the router knows about.
When you configure an include zone filter list, the interface advertises that it can
reach only those zones specified on the list. This type of filter list is useful if you
want to filter out most of the zones that the router knows about.
When you configure a zone filter list using the 5.X Include or 5.X Exclude
options, the interface advertises that it can reach only those zones you allow on
the list. The interface will always advertise the networks associated with the zones
in the zone filter list.
For more information about zone filters, see Chapter 2.
To change the zone filter type, begin at the Configuration Manager window
(F
igure 4-1):
1. Select Protocols > AppleTalk > Interfaces.
The AT Interface Configuration window appears (F
igure 4-3).
2. Click on Zone Filter.
The AppleTalk Zone Filter Configuration window appears (F
igure 4-5). It lists
the zone filters already configured for the router.
Note: By default, the zone filter type is set to Exclude.
Comentários a estes Manuais